Electronic Theatre Controls PARADIGM Instrukcja Instalacji Pobierz pdf (Strona 41)

5 Install Rack Options 37

Connect CAT5e Wiring

Step 1: Pull your CAT5e building wire through the conduit access previously prepared.

Step 2: The punch down connector provides insulation displacement therefore stripping

of wire is not required. Reference the connector label for the color code for Cat5e

wire using the 568B standard.

Step 3: Install the protective covers over the wire terminals.

Step 4: Install the punch down connector on the patch panel.

Step 5: Connect Ethernet patch cables.

a: Connect a patch cable from the left I/O to the first RJ-45 input on the Ethernet

Switch panel.

b: Connect a patch cable from the punch down connector to an RJ-45 input on

the switch panel. Repeat for each building service connection (up to four).

Step 6: Install the Ethernet Switch Module into the enclosure and secure it in place using

the captured screws provided.

Note:

All Ethernet terminations must follow IEEE 802.3 and be terminated to the T568B

standard.

Note:

Use a 110 punch down tool to complete the wire termination.

As needed, press here gently

with screwdriver to release

connector from panel.

1 2 ... 36 37 38 39 40 41 42 43 44

Brak uwag

Electronic Theatre Controls PARADIGM Instrukcja Instalacji Strona 41