Electronic Theatre Controls Emphasis Lighting Control System Dokumentacja Pobierz pdf (Strona 171)

Express 125/250 User Manual, v.3.1 157

Recording submasters

You can create submasters in Stage or Blind mode. Follow these steps to

record a simple, pile-on submaster:

Note: Use Solo to record specific channels into the submaster (rather than

the full stage look). For example: [5] [Thru] [1][0] [S7],

More Softkeys

[S3],

Solo

, [Solo] [Record] [Sub] [5] [Enter] records only the current levels

of channels 5 through 10 in submaster 5, regardless of what other channel

levels may be up on stage.

Fade and dwell times for submasters

Normally, pressing a sub bump brings channel levels to their recorded

level immediately. Channels stay at full recorded levels as long as the

bump button is held.

You can also set upfade, dwell and downfade times for submasters.

These times are activated for each submaster by its bump button. Upfade

time is the length of time it takes a submaster’s channels to fade to their

recorded levels when the submaster bump button is pressed. Dwell time

is the length of time the submaster’s channel levels stay at their full

recorded levels before the downfade starts. A manual dwell time means

that you can override the bump button fades with the slider (see

Controlling submaster fades manually, page 167 for more information).

Downfade time is the length of time it takes a submaster’s channels to

fade from their recorded levels to zero.

Fade times may be programmed from 0.1 seconds to 99:59 minutes. The

number may be entered in normal time format or in decimal format. When

entered with a decimal point, the number must be less than one minute

(0.1 to 59.9 seconds) to be accepted. When entered without a decimal

point, a 2-digit number will be treated as seconds if less than 60 and as a

calculated value of minutes and seconds if between 60 and 99. For

example, if you enter 70, the time will display as 1:10. If you enter either

a 3-digit or a 4-digit number, the last two digits, up to 59, are interpreted

as seconds. For example, if you enter 9930, the time will display as 99:30.

Keystrokes: Action:

1. Press [Stage].

Selects Stage display mode

2. Select channels and set

channel levels.

Creates look

3. Press [Record].

Prompt reads:

To record cue, select number and

press ENTER

To cancel, press CLEAR

4. Press [Sub] [5] [Enter]

or…

Press Submaster 5’s bump

button.

The current stage look is recorded into

submaster 5

68.

Defaults for upfade/dwell/downfade dwell times are 0/Manual/0. These default

times are true for pile-on or inhibitive submasters, but not for effect submasters.

See Effect fade times, page 214.

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 379 380

Komentarze do niniejszej Instrukcji

Brak uwag

Electronic Theatre Controls Emphasis Lighting Control System Dokumentacja Strona 171

Komentarze do niniejszej Instrukcji