Electronic Theatre Controls Emphasis Lighting Control System Instrukcja Użytkownika Pobierz pdf (Strona 199)

7 Macros 189

Sample Macros

The following macros are provided as useful samples. There are more macros available at

the ETC website: http://www.etcconnect.com/service/service_macros.asp.

Note:

Not all Expression macros are valid for the Emphasis Control System.

Channel Check

[At] [0][0] [+] [Full]

Each time you activate this macro, the next channel is brought to full as the previous

channel is taken out.

Automated Channel Check

[At] [0][0] [+] [Full] [Macro Wait - 5 seconds] [M#]

In this macro, each channel is brought to full for 5 seconds, then the macro repeats itself,

bringing up the next channel. [M#] is the macro’s own number.

Delayed Automated Channel Check

Macro 1: [Macro Wait - 1 minute] [M2]

Macro 2: [At] [0][0] [+] [Full] [Macro Wait - 5 seconds] [M2]

Sometimes you are responsible for doing the channel check and running the console. If you

need to have the automated channel check run, but you also need time to get from the

console to the stage, you can use these two macros to accomplish this task.

Turn Worklights On and Clear the Fader Pairs

[Channel] [x] [Full] [Clear - AB] [Clear - CD]

This macro brings a worklight channel [x] to full then clears the cues from the A/B and C/D

fader pairs. You can add a range of channels to your selection using the [And] and [Thru]

commands, if needed.

Turn Worklights On and Clear Both Faders and Background Channels

[Channel] [x] [Full] [Clear - AB] [Clear - CD] [S3 - Backgrnd Overrides] [Enter] [Enter]

This macro brings a worklight channel [x] to full then clears the cues from the A/B and C/D

fader pairs and any background channels. You can add a range of channels to your

selection using the [And] and [Thru] commands, if needed.

Turn Worklights On and Clear All Playbacks

[Channel] [x] [Full] [Clear - AB] [Clear - CD] [S3 - Backgrnd Overrides] [Enter] [Enter]

[S1 - Fadeout Subr] [Enter]

This macro brings a worklight channel [x] to full then clears the cues from the A/B and C/D

fader pairs, any background channels and any running subroutines on submasters. You

can add a range of channels to your selection using the [And] and [Thru] commands, if

needed.

1 2 ... 194 195 196 197 198 199 200 201 202 203 204 ... 317 318

Brak uwag

Electronic Theatre Controls Emphasis Lighting Control System Instrukcja Użytkownika Strona 199