Electronic Theatre Controls Emphasis Lighting Control System Instrukcja Użytkownika Pobierz pdf (Strona 231)

9 Control Interfaces 221

Step 12: If required, using the alphanumeric keyboard, enter the label for this event and

press [Enter].

Step 13: Press the down-arrow key [

v] to advance to the next event number. If no event

exists below this one, a new event will be created.

Step 14: Repeat steps 4 through 12 to create more events.

Note:

You can also use the right- and left-arrow ([t] and [s]) keys to move from column to

column, and the down- and up-arrow ([v] and [u]) keys to select other events to edit.

Create a time code program using Learn Mode:

Step 1: Press [Setup] [7] [Enter] to view the Time Code Events display. The display

defaults to event #1.

Step 2: Press [S6 - Learn Mode] to enable Learn Mode. “TimeCd Learn” flashes in red

in the upper left corner of the screen.

Step 3: If you are using the internal clock, press [S2 - Clock Enable] to start the clock

running.

Step 4: Press [Stage] to return to the stage display.

Step 5: If you are using external time code, start the clock running. Make sure you have

enabled Time Code Input in the Options Settings menu (see Time Code

Program, page 219).

Step 6: Play back the cues, submaster bump buttons and macros you need to record as

events as you want them to be played back by the time code program. Press

[Record] to record an empty event.

Step 7: When you are done, press Press [Setup] [7] [Enter] to view the Time Code

Events display. The display should contain events for each cue, submaster bump

and macro you played back.

Step 8: Press [S6 - Learn Mode] to disable Learn Mode. Use the direct entry method to

edit your recorded events.

Recording and editing the Time Code Program

As you initially create or edit a time code program, events are not automatically recorded

until you sort or exit the Time Code Events display. If time code is enabled and being

received, or the internal clock is running, Emphasis can run events as you edit them. Edits

are held in a buffer until you sort or exit the Time Code Events display, so the event that

runs may not perform your changes. To force the changes to take effect without leaving the

Time Code Events display, press <S7 - More Softkeys> [S8 - Sort].

Note:

You can also press [S6 - Learn Mode] [S6 - Learn Mode] to quickly reset the event

pointer and record your changes.

To edit an existing event, use the direct entry method described above. You can edit events

in ranges using the [And] and [Thru] keys when selecting events.

1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 317 318

Brak uwag

Electronic Theatre Controls Emphasis Lighting Control System Instrukcja Użytkownika Strona 231